Industrial Floor Surfaces

1. Foxmen – SuperTOP (SPL) – Impact and Abrasion Resistance Non-Metallic Floor Header Code - FM- IFS-130

• SUPERTOP-SPL is a factory blended ready to use cementitous nonmetallic floor hardener for all industrial areas subject to heaviest traffic.
  
  SUPERTOP - SPL is a ready to use nonmetallic dry shake floor hardener which provides a highly abrasion and impact resistance dust-free surface to concrete floors which withstand spillages of Oil Grease and certain industrial chemicals. SUPERTOP- SPL is easy to trowel in to the surface of fresh, wet concrete which cures monolithically to provide a dense, non porous, toughen and hard wearing surface suitable for industrial use.
  
  SUPERTOP - SPL has been tested as per IS 1237-1980 and found test result shows that
  
  SUPERTOP - SPL improves the abrasion resistance of concrete by 255%
  
  SUPERTOP-SPL has a compressive strength of 75 N/MM2 at 28 days. SUPERTOP-SPL can reduce the lighting requirement in industrial application and hence save energy costs in long term.
  
  Where to use - SUPERTOP-SPL is suitable for areas subject to constant impact such as quays, foundries, walkways, machine tool shops, car parks, garages, service stations, machine showrooms, shopping centres, warehouses, laboratories, abattoirs' bakeries subways, power stations, Engineering workshops etc.
  
  Benefits - Increased durability, Good impact and abrasion resistant, Forms monolithic bond with base concrete, Easy to use, factory controlled, Dust free, non slip surface, Resistant to Oil/Grease Spillages, Economical and very good finish.
  
  Technical Data -
  
  • Form: Gray Powder
  • Hardness: 7 Moh's
  • Water absolution: 6.0 to 6.5%
  Method of use - Base Concrete: The base concrete should have minimum cement content of 300 kg/m3 with water cement ratio being kept to a minimum to produce zero slump. Particular care should be taken at bay edges.
  
  Dosage - Heavy duty : 7 kg/m2 | Medium Duty: 5 kg/m2 | Light Duty : 3 kg/m2
  
  Dry Shake Method - SUPERTOP-SPL should be applied when the base concrete is sufficiently firm to take the weight of both workman and power float and leaving foot prints about 3 mm in depth no free water should be evident. Do not delay application when this point is reached.
  
  Broad Casting - Broad casting SUPERTOP-SPL in two equal stages first apply at the rate of 3.5 kg/m2 by sprinkling evenly on to the concrete surface carryout the first power trowel or hand trowel and then repeat the operation but broadcast the second stage at right angles to the first. Finally when the sheen begins to leave the surface, carry out power trowelling to close the pores and completely level the surface. Do not over trowel.
  
  Curing - Curing should be carried out immediately after the final trowelling operation has been completed.
  
  Storage - SUPERTOP-SPL has a shelf life of 12 monthsif kept in original, unopened packing. Protect from frost and moisture.
  
  Handling Precautions - SUPERTOP-SPL is mildly alkaline prolonged contact with skin should be avoided.